WaterJet Cut Aluminum Signs
WaterJet Cut Aluminum Signs
Step 1: Align your template in the desired location with a level, then tape it in place.
Step 2: Drill holes according to the template. Use an 12/64″ drill bit. Blow out any debris
Step 3: Simply thread the studs into the predrilled and threaded holes on the back of your sign. Do not over tighten. Slide a spacer over each stud.
Step 4: Squeeze a tiny bit of adhesive like PL Premium into each hole you drilled (only need a small amount as the stud occupies most of the space). Gently push the plaque into the holes, lightly tapping all around. Step back and check alignment.
Line up your sign making sure it is level and mark your screw holes.
Line up your sign making sure it is level and mark your screw holes.
For substrates that require it (such as stone and stucoo), pre drill a small hole where you marked in step one.
For substrates that require it (such as stone), pre drill a small hole where you marked in step one.
Use the appropriate length screw (provided with your sign).
Use the appropriate length screw (provided with your sign) and screw your sign onto your home.
Push the Decorative Nylon Caps into place covering the screw holes.
Push the Decorative Nylon Caps into place covering the screw holes.
Enjoy your sign that will become the envy of your neighbourhood for a lifetime to come!
Enjoy your sign that will become the envy of your neighbourhood for a lifetime to come!